Comptes Rendus

Table of contents

Volume articles

Synthesis
Comparison study on rock breaking characteristics of disc cutters under coupled static–dynamic loads and static loads
p. 1-15
Spontaneous articles
Average Surface Temperature Over the Circular Disk Heat Source/Sink Embedded in an Insulating Boundary Plane. Analytic Solution.
p. 17-27
Short paper
Risk-averse estimates of effective properties in heterogeneous elasticity
p. 29-42
Short paper
Continuous deformation analysis and contact force estimation for pneumatic bending actuators interacting with environment
p. 43-58
Short paper
Bregman divergences for physically informed discrepancy measures for learning and computation in thermomechanics
p. 59-81
Spontaneous articles
A Soft Landing Approach for the Centrifugal Microgel Synthesis Process
p. 83-102
Short paper
A fatigue-reliability approach using ultrasonic non-destructive inspection
p. 105-124
Spontaneous articles
A strain based Lipschitz regularization for materials undergoing damage
p. 125-149
Spontaneous articles
Deep Learning of Temperature – Dependent Stress – Strain Hardening Curves
p. 151-170
Spontaneous articles
The Laplace Virtual Fields Method for the direct extraction of viscoelastic properties of materials
p. 171-199
Evaluation of the PANS method for the prediction of the fluid flow in a cyclone separator
p. 201-218
Blow-up time of solutions to a class of pseudo-parabolic equations
p. 219-226
On the use of an high order perturbation method for numerical time integration in structural dynamics.
p. 227-245
A Variational Calculation of Diffusive Flux in a Mixed Boundary Value Problem
p. 247-263
A projection-based approach to extend digital volume correlation for 4D spacetime measurements
p. 265-280
Convection de Bénard–Rayleigh. Cas libre-libre
[Bénard-Rayleigh convection in the free-free case]
p. 281-313
Research article
Interfacial capillary–gravity short-crested waves
p. 315-334
Addendum: Average Surface Temperature Over the Circular Disk Heat Source/Sink Embedded in an Insulating Boundary Plane. Analytic Solution
p. 335
Stable schemes for second-moment turbulent models for incompressible flows
p. 337-353
A second-order resolvent formulation for the analysis of turbulent flow structures
p. 355-371
Research article
Dynamics of inclined CNTRC sandwich beams under a moving mass with influence of CNT agglomeration
p. 373-390
Research article
Bounds for the blow-up time a class of integro-differential problem of parabolic type with variable reaction term
p. 391-400
Research article
Intrinsic transition mechanism to detonation of gaseous laminar flames in tubes
p. 401-427
Research article
Finite strain formulation of the discrete equilibrium gap principle: application to mechanically consistent regularization for large motion tracking
p. 429-458
Research article
Exact expressions of the uniaxial perfectly elasto-plastic stress wave and induced mechanical fields in the case of a finite impact: application to laser shock peening
p. 459-484
Implementation of the c-phi reduction procedure in Cast3M code for calculating the stability of retaining walls in the layered backfill with strength parameters reduction by elasto-plastic finite element analysis using fields data
p. 485-523
Three-dimensional numerical study of a local scour downstream of a submerged sluice gate using two hydro-morphodynamic models, SedFoam and FLOW-3D
p. 525-550
Transfert de masse non-stationnaire depuis des particules sous écoulement
[Unsteady mass transfer from particles under flow]
p. 551-562
Frequency response of certain temporal and complex transfer functions for the Interfacial 1D temperature wave
p. 563-575